Xenosep® SPE Systems
Xenosep® SPE Systems for performing EPA Method 1664A are available in convenient Starter Kits for laboratories just starting out. Starter Kits include all components required to process one sample at a time. Additional components are available for scale up as required.
Extract Samples 5 Times Faster, Distill Samples 3 Times Faster, and Significantly Lower Cost per test...
Step 1
Extract 1L Sample
17 seconds is all it takes to filter a 40 mg/L* OPR and achieve 98% recovery. That’s 50 times faster than a typical single layer SPE filter with 89% recovery. In addition, triple layer Xenosep SPE Filters have 5 times the filtration capacity already built-in for the MS, MSD, and hard-to-filter samples.
*As required by EPA Method 1664A
Step 2
Elute and Dry Extract
Less filter clogging enables more efficient filter drying and eluting with less solvent. Xenosep sodium sulfate columns save time by eliminating off-line drying steps or repouring the extracted water sample back into the separatory funnel.
Step 3
Distill and Oven Dry Extract
Less extraction solvent means faster distillation. Final hexane extracts distill to dryness in about 10 minutes. Unique flat sided Xenosep flasks reduce oven drying times by 67% so you get QC tests in the dessicator 3 times faster than the other options below.
Xenosep part XE-26616 Starter Kit, 47 mm, 1 Position
Xenosep part XE-26618 Starter Kit, 47 mm, 3 Position
Xenosep part XE- 24547 SPE Filters, 1664A, 47mm
